BandStyle - Nylon Trail Loop “Denver”

1. prepare the bracelet
   Take the bracelet and open the Velcro fastener completely so that both ends can move freely.
2. putting on a watch
   Put your Apple Watch with the Denver band on your wrist. Make sure the watch is correctly positioned and hold it in place with your other hand.
3. adjust the fit
   Pull the loose end of the bracelet through the slot or loop on the other side. Pull until the bracelet is comfortably snug around your wrist, but not too tight.
4. Velcro fastener
   Press the Velcro end firmly onto the nylon strap to secure it to your wrist. Make sure the Velcro is tight along the entire length of the strap to ensure a secure fit.
5. fine-tuning
   Check the fit of the bracelet and adjust it if necessary by loosening or loosening the velcro fastener and making the band a little tighter or looser.
6. Check comfort
   Move your wrist to make sure the band is comfortable and not too loose or too tight. It should be tight enough to keep your Apple Watch securely on your wrist, but loose enough to be comfortable to wear all day.

Now you are ready to wear your "Denver" bracelet comfortably and safely, whether during sports or in everyday life!

The "Denver" bracelet is compatible with all Apple Watch series, including series 1 to 10, SE, Ultra and Ultra 2.

Yes, our bracelets come in a wide range of colors. You can choose from up to 19 different colors to complement your personal style or outfit.

How to clean your Nylon Trail bracelet

1. remove the bracelet
   Remove the band from your Apple Watch to allow for thorough cleaning and to prevent damage to the watch's electronics.
2. pre-rinse
   Hold the bracelet under lukewarm running water to rinse off any coarse dirt and debris. Avoid hot water, which could damage the material.
3. Prepare a mild soap solution
   In a small bowl, mix some mild dish soap or hand soap with lukewarm water. Avoid harsh chemicals or bleach that could damage the material.
4. cleaning the bracelet
   Dip a soft brush (e.g. a soft toothbrush) or a microfiber cloth into the soapy solution. Gently rub the bracelet, especially in very dirty areas and around the Velcro fastener. Be careful not to apply too much pressure to avoid damaging the fabric.
5. Wash
   Rinse the bracelet thoroughly under lukewarm running water to remove all soap residue. Make sure that no soap residue remains in the Velcro or fibers.
6. Dry
   Gently shake off any excess water from the bracelet and pat it dry with a clean, dry towel. Then let the bracelet air dry, ideally laid out flat on a towel. Avoid direct sunlight and heat sources to prevent deformation or material damage.
7. Reattach the bracelet
   Once the band is completely dry, you can reattach it to your Apple Watch and wear it as usual.

This simple care keeps your "Denver" bracelet clean and in good condition, so that you can enjoy it for a long time!

The bracelet will be shipped within 24-48 hours with DHL. The transport time then usually takes 2-4 working days.

Of course, we offer a 30-day return guarantee. Please see our return policy on the website.